Golden Aspen laminate flooring is a beautiful and affordable flooring option that can give your home a warm and inviting look. Installing laminate flooring is a relatively easy process that can be done in just a few steps. Here’s how to install Golden Aspen laminate flooring in your home:
Prepare the Subfloor
Before installing laminate flooring, you need to ensure that the subfloor is clean, dry, and level. Sweep or vacuum the subfloor to remove any dirt, dust, or debris. If the subfloor is uneven, you may need to use a self-leveling compound to even it out.
Acclimate the Laminate Flooring
Acclimate the Golden Aspen laminate flooring by leaving it in the room where it will be installed for at least 48 hours. This allows the planks to adjust to the temperature and humidity of the room, which can help prevent gaps or buckling in the future.
Install the Underlayment
The next step is to install an underlayment over the subfloor. The underlayment provides a moisture barrier, reduces noise, and helps the laminate flooring float. Unroll the underlayment and cut it to size using a utility knife. Overlap the seams of the underlayment by 8-10 inches and use duct tape to secure them together.
Measure and Cut the Laminate Flooring
Measure the length and width of the room to determine how many planks of Golden Aspen laminate flooring you’ll need. Use a table saw or circular saw to cut the planks to size. Be sure to leave a 1/4 inch gap around the perimeter of the room for expansion.
Install the Laminate Flooring
Starting in one corner of the room, lay the first plank of Golden Aspen laminate flooring against the wall with the tongue facing out. Use spacers to maintain the 1/4 inch expansion gap between the wall and the plank. Insert the tongue of the next plank into the groove of the first plank at a slight angle and press down to snap the planks together. Continue installing the planks in rows, staggering the seams by at least 8 inches between rows.
Cut Around Obstacles
When you encounter obstacles like doorways or heating vents, use a jigsaw or handsaw to cut the planks to fit around them. Be sure to leave a 1/4 inch gap around the obstacle for expansion.
Install the Final Row
When you reach the final row, you may need to rip the planks to fit. Use a table saw or circular saw to cut the planks to size, leaving a 1/4 inch gap between the wall and the plank. Use a pull bar and tapping block to tap the final row into place.
Install the Baseboard
Once the Golden Aspen laminate flooring is installed, install the baseboard or shoe molding to cover the expansion gap around the perimeter of the room. Nail the baseboard or shoe molding to the wall, not the floor.
Clean Up
Finally, remove the spacers and clean up any debris from the installation. Sweep or vacuum the floor to remove any dust or dirt.
In conclusion, installing Golden Aspen laminate flooring is a simple and straightforward process. That can be done in just a few steps. By properly preparing the subfloor, acclimating the laminate flooring, and using the correct tools and techniques, you can achieve a beautiful and durable flooring option for your home.